Ends December 11th !!!
We must get 10 people to do this pricing. This is $400 off my website pricing, and I NEVER discount these manifolds other than these group buys!
This group buy will end on Sunday 12/11/2016. Natural finish manifolds will ship around 3-4 weeks after the buy ends. Anodized manifold orders will ship roughly 5-6 weeks after the buy ends.
6 CYLINDER Pricing (2JZ and RB26):
6 injector, single fuel rail - $2395 SHIPPED - SAVE $400!!
12 injector, dual fuel rail - $2695 SHIPPED - SAVE $400!!
ANODIZING - ADD $200
4 CYLINDER Pricing (4G63 and SR20):
4 injector, single fuel rail - $1950 SHIPPED - SAVE $350!!
8 injector, dual fuel rail - $2250 SHIPPED - SAVE $350!!
ANODIZING - ADD $200
More info:
see more images
These manifolds cost less than a hypertune, and it's carbon fiber!!! The plenums are incredibly effecient, after a hard pull you can put your hand on the carbon surface. Try doing that with an aluminum intake! I personally made over 1700WHP with this intake running 45+PSI of boost, and these have been burst tested to 120PSI. If you want to two colors, red runners, black throttle body, black rails, add an additional $100. Throttle body can be 90mm or 102mm. Integrated wiggins machining available at no extra cost. If you want to do drive-by-wire, we can set this up for a GM LS3 throttle body (subtract $200 from pricing, you provide the throttle body). Shipping is included, but buyer is required to pay 3% paypal fees. Depending on anodizing options chosen, these will ship roughly 4-6 weeks from end of group buy date.
What throttle body should I choose?
I recommended the smaller size throttle bodies for street applications.
How much extra is wiggins flange, and is the clamp included?
Billet throttle body Wiggins flange machining no extra charge! The clamp assembly is not included. You can use Wiggins brand clamps or accufab brand clamps.
Where are the vacuum ports located?
The vacuum ports are located on the rear and underside of the plenum, hidden from view.
Is there an IACV (idle) port?
On 2JZ manifolds an -8AN port is on the underside, with a flange to adapt to the toyota IACV. This allows remote mounting of the stock valve with AN hose. Pretty cool!!
How much boost and power can this handle?
On my 2JZ Supra I personally made 1741 RWHP with this manifold at 48psi + 225 shot of nitrous. These are very well built and can handle power, and they experience almost no heat soak like an aluminum manifold.
Who makes this manifold?
The entire manifold is built by CPC in Australia.
What port size should I choose?
The port size is really dependent on your head porting. If you have a gasket matched head port, then you should go with the "big port". If your on stock ported head, I would recommend "standard port". I made 1741RWHP on standard porting, so it is not going to hold back your power production with standard porting.
Fill out the form below, and I will send you a paypal invoice. Please make sure to fill out all fields. You have to give a deposit to join the group buy, no exceptions!