In part six of the auto to manual conversion series, I cover the installation of the Tilton ST246 clutch.

A couple tips shown in the video:

1. Wiggle the billet alignment tool gently as you install all the pressure plate bolts in a cross pattern. The index tool should slide on and off easily after the clutch is fully installed. This will help you greatly when you go to slide the transmission onto the clutch.

2. Use the alignment tool to help you hold the clutch as you install it. Torque your flywheel to 75 ft lbs. Torque your pressure plate to your clutch manufacturers specifications. On this clutch, they recommend 35 ft lbs.

VIDEO BELOW